TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
FORWARD CLUTCH REASSEMBLY
Figure 197
Compress return spring and install retainer ring, being certain
Figure 194
ring is in full position in retaining washer and ring groove.
Install clutch piston inner and outer seal rings. Install piston in
clutch drum, use caution as not to damage seal rings.
Figure 195
Figure 198
Position the inner return spring retainer, the return spring and
Install one steel disc.
outer spring retainer. NOTE: If forward and reverse clutches
are modulated, assemble piston return disc springs as
shown in Figure A on page 59
Figure 199
Figure 196
Install one friction disc. Alternate steel and friction discs until
Position return spring retainer ring retaining washer on clutch
the proper amount of discs are installed. First disc next to the
shaft.
piston is steel, last disc installed is friction.
--34--
F-79