TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 223
Figure 226
coat outer diameter of oil seal with Permatex No. 2 and press
Install front bearing cap and shims. Tighten bolts to specified
seal in bearing cap with lip of seal in. See assembly instruction
sheet for seal depth. Using new "O" rings install rear output
Loosen front bearing cap bolts.
bearing cap, oil seal and taper bearing cup on transmission
case. Lube opening in bearing cap must be aligned with lube
opening in case.
Figure 227
Using a inch lb. torque wrench, determine the rolling torque of
the output shaft and record. Tighten front bearing cap botls to
Figure 224
specified torque. Check rolling torque with bolts tight. Torque
Tighten bearing cap bolts to specified torque.
(See torque
must be 6 to 8 inch lbs. [0.7-0.09 Nm] more than when bearing
chart.)
cap bolts were loose. Add or omit shims on the front bearing
cap to achieve the proper preload.
Figure 225
Coat outer diameter of front output oil seal with Permatex No. 2.
Figure 228
Install seal at bearing cap with lip of seal in.
Position reverse and 3rd clutch in transmission housing.
--39--
F-84