TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 232
If idler shaft was disassembled, install front bearing. Install idler
Figure 229
gear on shaft with long hub of gear up. (6 speed will have two
From the rear of the transmission case, install the low (1st)
gears on the idler shaft). Install rear inner taper bearing with
clutch.
large dismeter of taper down. Install bearing spacer and double
bearing cup with outer diameter locating ring groove up. Install
outer taper bearing with large diameter of taper up. NOTE:
Double taper bearing must be replaced as an assembly as the
bearing spacer is pre-selected at factory.
Figure 230
Install low (1st) speed drive gear on clutch shaft.
Figure 233
Install idler shaft assembly. NOTE: Lock ball in bearing cup.
Figure 234
Install low (1st) clutch outer double taper bearing. NOTE: Locat-
Figure 231
ing ring groove in bearing cup to be out (to the rear).
Install drive gear retainer ring.
--40--
F-85
