TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 235
Figure 238
Use caution as not to lose low (1st) and idler bearing lock balls.
Tap cover in place.
A light coat of grease will hold lock balls in place.
Figure 236
Figure 239
The use of saligning studs will facilitate rear cover installation.
Install rear cover bolts and washers, tighten to specified torque.
Position a new gasket and "O" ring on rear of case. A light coat
(See torque chart).
of grease will hold gasket in place.
Figure 240
From the front, tap the low (1st) clutch and idler shaft to the rear
Figure 237
to expose the rear bearing locating ring groove. Install locating
Align lock balls in bearing with notches in rear cover.
ring.
--41--
F-86