TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 6
Position high and low range gears, shift hub, hub sleeve and
needle bearings in transmission case as shown in Figure 5.
Insert output shaft, front bearing and thrust washer through out-
put gears. Use caution as not to damage high and low range
Figure 4
gear needle bearings.
Remove front output flange nut, washer, "O" ring, flange and
bearing cap from housing. Block output gears. Push output
shaft from rear through gears and taper bearing.
Proceed with Figure 72 through 216 in the R & HR 32000 Series
3-Speed Maintenance Section than refer to Figure 5 below.
REASSEMBLY
(See cleaning and inspection page.)
Figure 7
Position output gear thrust washer and rear taper bearing on
output shaft.
Figure 5
View of output shaft as it would be positioned in transmission
case. NOTE: Front bearing cone and output gear thrust washer
Figure 8
Block output shaft from the front and install rear taper bearing.
shouldered on shaft with large diameter of bearing in.
--86--