TM 5-2420-230-24-1
7.2.4 Output test
When EGS is held in the forward down position while power is applied, OUTPUT TEST mode is
activated.
In this mode, driving is not possible, since all EGS outputs remain off until the testmode is left.
LED's '1'-'8' light up sequentially during output test :
First LED '1' is switched on shortly, then LED '2' etc...
When LED '8' is switched off, LED '1' is again switched on and so on.
The colour of the LED indicates its status :
COLOUR
STATUS
GREEN
OUTPUT OK
YELLOW
OUTPUT NOT CONNECTED OR SHORTED TO BATTERY PLUS
RED
OUTPUT SHORTED TO GROUND (OR TO ANOTHER OUTPUT)
The LED numbers correspond to output wires as follows :
LED NUMBER
OUTPUT WIRE
1
6
2
7
3
4
4
5
5
9
6
13
7
8
8
3
Note : to find the function of the corresponding output wires - see EGS Functional Description
EGS user manual. Page 23 of 25
SPICER CLARK-HURTH
Document reference : egsman4.doc
Revision date: 07/04/97
Ten Briele 3, 8200 Brugge, Belgium
Tel: +32/50/402445
Fax: +32/50/402402
G-25
