TM 5-2420-230-24-1
Spicer Speciality Axle Division - Technical Publications
TP1193
KIRKSTALL SPECIALITY AXLE DIVISION
STANDARD STUDS - FITTED INTO MACHINED CHAMFERED HOLES
STUDS TO BE INSERTED UNTIL THREAD RUN-OUT LOCKS INTO PARENT METAL
TP1152
TP1151
MACHINED CHAMFER
INCORRECT
CORRECT
IMPORTANT :- THIS STUD FITTING PROCEDURE IS TO BE USED IN LIEU OF STATED
TORQUE VALUES ON EXISTING ARRANGEMENTS.
NEW ARRANGEMENTS WILL SPECIFY TD183/1 FROM THE DATE OF
ISSUE.
SPECIAL STUDS - FITTED INTO MACHINED PARALLEL COUNTERBORE
STUDS TO BE INSERTED UNTIL CORRECT TORQUE VALUE IS OBTAINED -
AS SHOWN ON RELEVANT ARRANGEMENT DRAWING
TP1153
BOTTOM OF THE C/BORE
AND STUD THREAD RUN-OUT
MACHINED PARALLEL
COUNTERBORE
THIS SPECIFICATION IS FOR STUD FITTING ONLY ;
NUTS & SETSCREWS MUST BE TORQUED TO VALUE SPECIFIED
Alteration Numbers
ISSUE A
DISTRIBUTION
TD183/1
STUD FITTING
Front Axle B.U.
PROCEDURES
Drive Axle B. U.
SHT 1 OF 1
Production
Manual No. 1785 Issue A
Page No.E23
Spicer Speciality Axle Division
J-133