TM 5-2420-230-24-2
Section 1 - Cylinder Block - Group 1
Balancer - Assembly (1-34)
B Series Shop Manual
Page 1-51
Press the bearings out of the balancer housing.
Balancer - Assembly (1-34)
The oil hole in the center bearings must align with the oil
hole in the housing. Mark the housing and bearings so
you can align the holes.
Caution: Press against the end of the bearing that has
the identification mark. Failure to do so will result in
damage to the bearing.
Press in the new center bearings until flush with the
housing.
Install the bearings in the housing so the identification
marks are toward the outside of the housing.
L-254