TM 5-2420-230-24-2
Balancer - Assembly (1-34)
Section 1 - Cylinder Block - Group 1
Page 1-52
B Series Shop Manual
Caution: Press against the end of the bearing that has
the identification mark. Failure to do so will result in
damage to the bearing.
Press in the new bearings until flush with the inside of the
housing.
The balancer shafts must be sub-assembled before being
installed into the housing. The assembly procedure is the
same for both shafts.
Use 500 grit sandpaper to polish the bearing surfaces
and to remove burrs and Loctite material.
Use cleaning solvent to clean the shafts and bearing
surfaces.
Hammer or Mallet
Install a new roll pin into one of the center holes in the
shafts.
A = 2.5 mm [0.09 (3/32) in]
Apply a coat of Loctite 609 to the bearing surface of the
shaft. Slide a new inner race into position on the shaft.
L-255
