TM 5-2420-230-24-2
Tappet (004-015)
B3.9 and B5.9 Series Engines
Page 4-6
Section 4 - Cam Followers/Tappets - Group 04
Pull the wooden dowel from the tappet bore allowing the
tappet to fall into the plastic trough.
Flashlight
When the tappet is dropped into the trough, most of the
time it will fall over. However, if it does not, gently shake the
trough just enough to allow the tappet to fall over before
removing.
NOTE: When removing the No. 6 cylinder tappets, take
special care not to knock or shake the tappet over the end
of the trough.
Carefully pull the trough and tappet from the cam bore, and
remove the tappet. Repeat the process until all tappets are
removed.
L-850