TM 5-2420-230-24-2
B3.9 and B5.9 Series Engines
Tappet (004-015)
Section 4 - Cam Followers/Tappets - Group 04
Page 4-9
Feed the installation tool through the cam bores by care-
fully pulling the trough/installation tool out the front. The
barrier at the rear of the trough will pull the tool out most
of the time.
NOTE: If the tappets have previously been used, each
tappet must be installed in the same postion as it was
removed from the engine.
Lubricate the tappets with clean lubricating engine oil.
Insert the installation tool into the tappet.
NOTE: To aid in removing the installation tool after the
tappet is installed, work the tool in and out of the tappet
several times before installing the tappets.
Slide the trough into the cam bore.
L-853