TM 5-2420-230-24-2
Fuel Injection Pumps, In-Line (005-012)
B3.9 and B5.9 Series Engines
Page 5-26
Section 5 - Fuel System - Group 05
CAUTION
The governor housing must be prelubricated before
engine operation. Failure to do so can result in prema-
ture governor wear.
Remove the access plug.
Add the following quantity of clean lubricating engine oil:
RSV 450 mL [0.48 qt]
RQV 750 mL [0.79 qt]
RQVK 750 mL [0.79 qt]
24 mm
Remove the fuel injection pump timing pin plug, reverse
the position of the timing pin, and install the timing pin,
plug, and sealing washer.
Torque Value: 27 Nm
[20 ft-lb]
30 mm
Tighten the fuel injection pump drive nut.
Torque Value:
"A" Pump
85 Nm
[63 ft-lb]
P3000/P7100
195 Nm
[144 ft-lb]
Nippondenso
123 Nm
[91 ft-lb]
Install the gear cover access cap hand-tight.
10 mm
Install the fuel injection pump mounting bracket capscrews.
Tighten all capscrews by hand for proper alignment.
Torque Value: 24 Nm
[18 ft-lb]
L-886
