TM 5-2420-232-10
0005
STOPPING AND PARKING MACHINE CONTINUED
5.
Backhoe:
a.
If the backhoe boom lock (WP 0004) and swing locks (WP 0004) are installed, the machine can be parked without
any other action to the backhoe being taken.
b.
Otherwise, engage both the backhoe boom lock and swing locks (WP 0004).
or
Lower the backhoe work tools to the ground, as shown below (bucket fully open, boom and dipper fully extended)
435-A0325
Figure 12. Machine Position for Parking
05
6.
Run the engine at 1,000 rpm (approximately) and reduced load for 2 to 3 minutes before shut down. This will allow the
turbocharger to cool.
7.
If you are leaving the machine, ensure all switches are set to OFF, close and latch all windows, and close both doors.
8.
If the lights are not required, turn OFF the battery disconnect switch (WP 0004).
9.
Use the handholds and 3-point contact method when you climb down from the machine.
10. Ensure the filler cap is secure.
END OF TASK
0005-13