TM 5-3805-280-24-2
Removal and Installation
Bracket and Mount-to-Frame Cap Screw--Specification
2. Slide engine toward hydraulic pump to engage
pump coupler.
Torque................................................................... 350 Nm (260 lb-ft)
3. Install cap screws (D) and nuts (I). Tighten cap
screws.
04
0400
9
TX,04,UU3873
1918SEP982/4
4. Install hydraulic pump using DFT1119 Pump Support
(A) and a small winch hoist (B). (See procedure in
Group 3360.)
5. Connect heater hoses.
6. Install air conditioner compressor and bracket, if
equipped.
7. Connect all wiring harnesses and starter cables.
8. Install speed control linkage. (See procedure in Group
0515.)
A--DFT1119 Pump Support
B--Winch Hoist
Continued on next page
TX,04,UU3873
1918SEP983/4
13-9