TM 5-3805-280-24-2
Removal and Installation
REMOVE AND INSTALL STARTER
IMPORTANT: Always disconnect the negative (-)
battery cables before removing starter
or a short circuit could result.
1. Disconnect negative (-) battery cables at battery.
2. Remove nut (A) to disconnect positive battery cable.
3. Remove nut (B) to disconnect negative (ground) cable.
04
0400
23
A--Nut
B--Nut
CAUTION: The approximate weight of starter is
D--Cap Screw and Lock Washer (3 used)
23 kg (50 lb).
Starter--Specification
Weight................................................................ 23 kg (50 lb) approximate
5. Remove cap screws and lock washers (D). Remove
starter.
6. Replace parts as necessary.
7. Install starter.
8. Tighten cap screws.
Starter Mounting Flange-to-Flywheel Housing Cap Screw--
Specification
Torque ............................................................................. 47 Nm (35 lb-ft)
9. Connect solenoid connector.
10. Connect positive battery cable.
11. Connect negative cable.
12. Connect negative battery cables at battery.
TX,04,UU3878
1918SEP981/1
13-23