TM 5-3805-280-24-2
Removal and Installation
17. Remove oil fill plug (A) from governor housing and
add 0.237 L (1/2 pint) of clean engine oil. Install plug.
18. Bleed fuel system. (See Bleed Fuel System in this
group.)
19. Check and adjust fast and slow idle stops. (See
Injection Pump Fast and Slow Idle Stops Adjustment
in Group 0515.)
20. Connect engine speed control cable.
04
0400
18
21. Do Engine Control Motor and Sensor Adjustment and
A--Oil Fill Plug
then the Engine Speed Learning Procedure. (See
procedures in Group 0515.)
TX,04,UU3876
1918SEP986/6
BLEED FUEL SYSTEM
1. Open bleed screws (A) on final fuel filter and primary
fuel filter (water separator).
2. Operate hand primer (B) until fuel fills separator bowl
and until fuel escapes from bleed screw on primary
fuel filter.
3. Tighten bleed screw.
4. Operate hand primer (B) until fuel escapes from final
fuel filter bleed screw.
5. Tighten final fuel filter bleed screw.
A--Bleed Screws
B--Hand Primer
TX,04,DH5310
1917SEP981/1
13-18