TM 5-3805-280-24-2
Removal and Installation
8. Install drive gear-to-pump hub cap screws (B) and
tighten.
Drive Gear-to-Pump Hub Cap Screw--Specification
Torque ............................................................................. 47 Nm (35 lb-ft)
9. Remove JDG886 Injection Pump Timing Pin (A) from
injection pump hub.
10. Install injection pump drive gear and new O-ring, if
04
needed. Tighten cap screws.
0400
16
Injection Pump Drive Gear-to-Hub Cap Screw--Specification
Torque ............................................................................. 27 Nm (20 lb-ft)
A--JDG886 Injection Pump Timing Pin
B--Cap Screw
Continued on next page
TX,04,UU3876
1918SEP983/6
13-16