TM 5-3805-280-24-2
Cylinder Head and Valves
05
2. Measure push rod OD (B). If OD is less than
23
specification, install a new push rod.
Fuel Supply Pump Push Rod--Specification
OD ................................................................................. 9.891--9.917 mm
(0.3894--0.3904 in.)
B--Push Rod OD
RG,05,DT7370 1911NOV972/4
3. Check crown on push rod ends. If flat or concave,
replace push rod and check camshaft lobe for wear.
(See Group 16).
RG,05,DT7370 1911NOV973/4
4. Measure push rod bore ID (C) in block.
Fuel Supply Pump Push Rod Bore in Block--Specification
ID ................................................................................... 10.00--10.05 mm
(0.3937--0.3957 in.)
Repair or replace block as necessary.
5. Lubricate push rod with clean engine oil and install in
bore with same end orientation as removed.
C--Bore ID
RG,05,DT7370 1911NOV974/4
13-81