TM 5-3805-280-24-2
Camshaft, Balancer Shafts and Timing Gear Train
16
Item
Measurement
Specification
9
Upper Idler Gear Bushing
ID
69.802--69.832 mm (2.7481--
2.7493 in.)
Upper Idler Gear Bushing,
ID
44.48--44.53 mm (1.751-1.753 in.)
6010-6910, 7405, 7410 Tractors (S.
N. 517001CD-- )
Lower Idler Gear Bushing
ID
44.489--44.539 mm (1.7515--
1.7535 in.)
Upper Idler Gear Shaft
OD
69.757--69.777 mm (2.7463--
2.7471 in.)
Upper Idler Gear Shaft, 6010-6910,
OD
44.43--44.46 mm (1.749-1.750 in.)
7405, 7410 Tractors (S. N.
517001CD-- )
Lower Idler Gear Shaft
OD
44.437--44.463 mm (1.7495--
1.7505 in.)
Upper Idler Gear Bushing-to-Shaft
Oil Clearance
0.075--0.125 mm (0.0030--0.0049
in.)
Lower Idler Gear Bushing-to-Shaft
Oil Clearance
0.026--0.102 mm (0.0010--0.0040
in.)
Upper and Lower Idler Gear
End Play
0.095--0.145 mm (0.0037--0.057
in.)
Lower and Upper Idler Shaft Spring
Protrusion
2.79--4.83 mm (0.11--0.19 in.)
Pin Protrusion (D)
Front Plate Countersunk TORX
25 Nm (18 lb-ft)
Screws (A)
Front Plate Threaded Studs (B) and
35 Nm (26 lb-ft)
(C)
Balancer Shaft Thrust Plate Cap
40 Nm (29.5 lb-ft)
Screws
Balancer Shaft Removable Weights
58 Nm (43 lb-ft)
TORX is a registered trademark of Camcar/Textron
Continued on next page
DPSG,OUO1004,232
1910JUL984/5
13-241
