TM 5-3805-280-24-2
Camshaft, Balancer Shafts and Timing Gear Train
16
INSTALL CAMSHAFT BUSHING
18
IMPORTANT: Bushings must be installed so oil
supply hole in bushing aligns with oil
drilling in block bore.
1. Mark orientation of oil supply hole (C) on front face of
block and on bushing to help with bushing alignment
during installation.
2. Apply TY6333 High-Temperature Grease to ID and OD
of new bushing (A), and to ID of bushing bore. Slide
bushing onto JDG739-5B Bushing Installer (B) so
notched end of bushing will be toward front end of
engine when installed.
3. Thread JDG739-4 Bushing Installer Screw into
JDG739-3 Removing/Installing Plate. With bushing
started, square in bore and oil hole aligned, tighten
forcing screw until flange of bushing driver bottoms
against face of block.
4. Remove bushing tool from cylinder block and check oil
supply hole for correct alignment. If holes are not
aligned, remove and discard bushing. Install a new
bushing.
A--Bushing
B--JDG739-5B Bushing Installer
C--Oil Supply Hole
RG,16,DT7505 1914NOV974/4
13-250