TM 5-3805-280-24-2
Speed Controls
REMOVE AND INSTALL ENGINE SPEED CONTROL CABLE
05
0515
6
A--Nut (2 used)
E--Bracket
H--Bracket
J--Engine Control Motor
B--Lock Washer (2 used)
F--Speed Control Cable
I--Engine Control Motor
and Sensor
C--Injection Pump Lever
G--Cap Screw and Lock
Arm
D--Ball Joint (2 used)
Washer (6 used)
cable are centered in brackets. As needed, adjust
IMPORTANT: The ball joints (D) are installed on
cable in brackets to connect ball joint to lever or
the cable to full thread engagement.
arm.
A ball joint can be used to lengthen
a cable end, if needed, but must
3. Connect ball joint to the OUTER hole of engine
have at least 6 mm (1/4 in.) of thread
control motor arm (I).
engagement to avoid stripping the
threads on cable end.
4. Do Engine Control Motor and Sensor Adjustment
and then the Engine Speed Learning Procedure.
1. Install ball joints (D) to full thread engagement.
(See procedures in this group.)
Tighten the nuts.
2. Install speed control cable (F) in brackets (E and
H). Initially, tighten nuts so threaded portions of
TX,05,UU3887
1918SEP981/1
14-17