TM 5-3805-280-24-2
Speed Controls
4. Check that engine speed control cable is connected to
the outer hole of engine control motor arm (B).
5. Loosen cap screw (A) in engine control motor arm (B).
6. Adjust the arm (B) on the shaft so the injection pump
lever just makes contact with the slow idle stop screw.
7. Tighten cap screw (A).
Engine Control Motor Arm-to-Shaft Cap Screw--Specification
Torque .......................................................................... 13 Nm (115 lb-in.)
A--Cap Screw
8. Do Engine Speed Learning Procedure. (See procedure
B--Arm
in this group.)
05
0515
9
TX,05,UU3889
1918SEP982/2
ENGINE SPEED LEARNING PROCEDURE
When the following components are repaired or replaced,
or when engine speeds deviate from specification, the
engine speed learning procedure must be performed.
Engine
Engine speed control cable
Engine control motor and angle sensor
Engine and pump controller
Fast and slow idle stop screws
1. Stop engine. Ignition key OFF.
2. Disconnect the laptop computer from test connector.
Wait for 5 seconds.
Continued on next page
TX,05,GG2769 1918SEP981/2
14-20
