TM 5-3805-280-24-2
Wiring Harness and Switches
REMOVE AND INSTALL PROPEL ALARM
CANCEL SWITCH AND START AID SWITCH
1. Disconnect battery ground (-) cable.
2. Remove cap screws. Remove upper cover.
3. Disconnect wires (C and D). Remove switches (A and
B).
4. Replace parts as necessary.
5. Install switches.
A--Propel Alarm Cancel Switch
B--Start Aid Switch (not shown)
6. Connect wiring connectors.
C--Start Aid Wire (not shown)
D--Propel Alarm Wire
7. Install covers.
8. Connect battery ground (-) cable.
TX,16,UU3963
1919SEP981/1
16
1674
15
REMOVE AND INSTALL STARTER SWITCH
1. Disconnect battery ground (-) cable.
2. Remove four cap screws from under control lever boot.
3. Turn cover. Remove cap screws.
4. Disconnect wiring harness connector (B).
5. Replace parts as necessary.
A--Screw (3 used)
B--Connector
C--Key Switch
Continued on next page
TX,16,UU3964
1919SEP981/2
16-46