TM 5-3805-280-24-2
Buckets
12. Check that a maximum clearance (see
13. Install retaining cap (4), washers (5), and two cap
specification below) exists between any of the joint
screws (6).
bearing faces. The clamp must be centered to the
excavator arm. If not, reassemble and re-shim
14. Rest the clamp against the bucket. Align the
until centered.
hydraulic cylinder end to the clamp.
Hydraulic Thumb--Specification
15. Install pin (7) and cap screw (8) and nuts (9).
Clearance............................................................................... .060 inch
CED,OUOE042,74 1908APR992/2
33
3302
13
21-13