TM 5-3805-280-24-2
Hydraulic System
6. Install spacer ring (10) into housing bore for rear pump
drive shaft.
10--Spacer Ring
TX,33,UU3784
1921SEP982/9
7. To help installation of drive shafts (3 and 4), heat
pump housing using a heat gun such as the JT07010
Two Temperature Heat Gun.
Pump Housing Heat--Specification
Temperature ......................................................... 50--80C (122--176F)
8. Apply a film of oil to outer race of bearings. Install the
drive shafts.
9. Install and tighten special fittings (15).
Special Plug-to-Pump Housing Special Fitting--Specification
3--Drive Shaft
4--Drive Shaft
Torque .......................................................................... 34 Nm (300 lb-in.)
15--Special Fitting
10. Apply grease to lips of oil seals. Install oil seals with
lip (spring side) towards inside of housing. Install
snap rings.
33
3360
41
Continued on next page
TX,33,UU3784
1921SEP983/9
21-81