TM 5-3805-280-24-2
Hydraulic System
CAUTION: To avoid injury from escaping fluid
under pressure, stop engine, and relieve the
pressure in the system before disconnecting
hydraulic or other lines. Tighten all connections
before applying pressure.
7. Disconnect lines (G) from cylinder.
8. Take notice of washer (J) locations for assembly.
Remove parts (H--K) to remove cylinder.
9. Repair or replace cylinder.
10. Install washers (J) equally on each side of cylinder
head end to get the minimum amount of clearance in
joint.
11. Align pin bores so dust seals are not damaged as
boom cylinder-to-frame pin (K) is installed.
Install pin (H) and retainer ring (I).
12. Connect the lines (G).
G--Rod End-to-Boom Section Bottom Port Line
--Head End-to-Boom Section Top Port Line
H--Pin
I--Retainer Ring
J--Washer (As Required)
K--Boom Cylinder-to-Frame Pin
TX,33,UU3810
1922SEP984/5
Continued on next page
33
3360
146
21-178