TM 5-3805-281-10
Maintenance--Every 2000 Hours
ENGINE CONTROL MOTOR AND SENSOR
ADJUSTMENT
When the following components are repaired or replaced,
or when engine speeds deviate from specification, the
engine control motor adjustment and engine speed
learning procedure must be performed.
Engine
Engine speed control cable
Engine control motor and angle sensor
Engine and pump controller
1. Check that fast and slow idle stop screws on the
injection pump are adjusted to specification.
2. Turn key switch to ON.
3. Turn the engine rpm dial to slow idle.
CED,TX14740,6097
1920APR981/2
4. Loosen cap screw (A) in engine control motor arm (B).
5. Adjust the arm on the shaft so the injection pump lever
just contacts the slow idle stop screw.
6. Tighten cap screw to 13 Nm (115 lb-in.).
Cap Screw--Specification
Torque .......................................................................... 13 Nm (115 lb-in.)
7. Do Engine Speed Learning Procedure in this group.
CED,TX14740,6097
1920APR982/2