TM 5-3805-281-24-1
Track System
Track Pin--Specification
Minimum used is the maximum allowable wear for
turning pins and bushings.
OD................................................................. 47.57 mm (1.87 in.) new
OD......................................................... 44.57 mm (1.75 in.) minimum
Measure bushing outer diameter at the two worn
used
places using a caliper such as the D17524C1 100
01
mm Caliper from JT05518A or JT05523
Bushing--Specification
0130
Undercarriage Inspection Service Tool Kit.
29
ID .................................................................. 48.40 mm (1.91 in.) new
ID .......................................................... 49.43 mm (1.95 in.) minimum
Master Pin--Specification
used
OD................................................................. 47.30 mm (1.86 in.) new
OD......................................................... 44.30 mm (1.74 in.) minimum
used
Master Bushing--Specification
ID .................................................................. 47.90 mm (1.89 in.) new
ID .......................................................... 50.90 mm (2.00 in.) minimum
used
CED,OUOE023,130
1922MAY982/2
DISASSEMBLE AND ASSEMBLE TRACK
CHAIN TO REPLACE BROKEN PART
NOTE: It is not necessary to completely disassemble a
chain to replace a broken part. If a track press is
available, refer to the operator's manual. If a track
press is not available, do the following procedure.
1. Remove track shoe from broken link assembly.
Remove track. (See procedure in this group.)
Continued on next page
TX,01,VV2529
1916MAR981/5
