TM 5-3805-281-24-1
Track System
CAUTION: Prevent possible injury from high
pressure grease in track adjuster cylinder. Do
not remove grease fitting or nut and valve
assembly to release grease.
01
0130
IMPORTANT: Prevent possible damage to track
33
components. Do not use the grease
fitting on track adjuster cylinder for
lubrication. Use this grease fitting only
for track sag adjustment.
5. To decrease track sag, add multi-purpose grease to
track adjuster cylinder through grease fitting (A) located
in access hole (D) in track frame. Use a grease gun
with a maximum capacity of 68 950 kPa (690 bar)
(10,000 psi).
To increase track sag, loosen nut and valve assembly
(B) one turn to release grease from track adjuster
cylinder through bleed hole (C) in rod. Tighten nut and
valve assembly when track sag is correct.
Nut and Valve Assembly--Specification
Torque ......................................................................... 147 Nm (108 lb-ft)
A--Grease Fitting
NOTE: If piston in track adjuster cylinder does not move,
B--Nut and Valve Assembly
remove the cylinder to make repairs. (See
C--Bleed Hole
Remove and Install Track Adjuster in this group.)
D--Access Hole
CED,OUOE023,132
1922MAY983/3
9-33
