TM 5-3805-281-24-1
Hydraulic System
CAUTION: DO NOT heat oil over 182C (360F).
Oil fumes or oil can ignite above 193C (380F).
Use a thermometer. DO NOT allow a flame or
heating element to come in direct contact with
the oil. Heat the oil in a well-ventilated area.
Plan a safe handling procedure to avoid burns.
12. Heat bearing cones (C and E).
Bearing Cone--Specification
02
0260
Temperature ......................................................... 70--90C (158--194F)
19
13. Install bearing cone (E) on motor drive shaft (A).
Make sure cone is tight against shoulder of shaft.
Install outer race of bearing.
14. Install outer race of bearing (C) in spacer (D). Make
sure race is tight to bottom of bore. Install race and
spacer with spacer notches towards larger bearing.
15. Install bearing cone (C) tight against outer race.
16. Apply clean oil to threads of a new nut (B). Install nut
with thin shoulder away from bearing.
A--Motor Drive Shaft
B--Nut
C--Roller Bearing
D--Spacer
E--Roller Bearing
Continued on next page
CED,OUOE023,174 1901JUN987/14
10-58
