TM 5-3805-281-24-2
Cylinder Head and Valves
Inspect cap screw bosses, must be clean/intact.
8. Proceed with the following dimensional checks and
visual inspections:
Cylinder Liner (See Group 10.)
Cylinder Head (See Group 05.)
Check liner flange flatness/finish.
Check liner flange thickness (if liner is removed).
Check surface flatness/finish.
Inspect flange for damage.
Inspect for surface damage.
Check cylinder head thickness, if resurfacing.
Cylinder Head Cap Screws (See Group 05.)
Cylinder Block and Liners (assembled and
Inspect for corrosion damage.
clamped) (See Group 05 or 10.)
Inspect condition of threads.
Check liner standout at four places on each liner.
Inspect for straightness.
Check liner standout difference between
Check length.
cylinders.
9. When inspections and measurements have been
completed, determine most probable causes of joint
Cylinder Block (See Group 10.)
failure. Make all necessary repairs to joint
Check surface flatness/finish.
components, cooling system, and fuel injection
Inspect for surface damage.
system.
Check liner counterbore depth (if liner is
10. Reassemble the engine according to procedures
removed).
Check top deck to crankshaft centerline
and specifications in the repair groups of this
manual.
dimension.
RG,RG34710,1074
1923OCT972/2
11-105
