TM 5-3805-281-24-2
REMOVE CRANKSHAFT REAR OIL SEAL
AND WEAR SLEEVE (WITH OIL SEAL
HOUSING INSTALLED)
Using JDG719 Seal Puller Adapter along with JDE38-2
Shank and JDE38-3 Slide Handle is the preferred method
for removing the crankshaft rear oil seal. If JDG719,
JDE38-2, and JDE38-3 are not available, JDG22 Seal
Remover can be used to remove the seal. Follow same
procedure for both pullers.
IMPORTANT: If rear oil seal is replaced, also replace
rear wear sleeve (as a matched set).
NOTE: If oil seal housing is to be removed, remove seal
and wear sleeve after housing is removed. See
REMOVE REAR OIL SEAL HOUSING AND
WEAR SLEEVE (with engine disassembled), later
in this group.
1. Remove rear drive hub (if equipped) and flywheel. See
REMOVE FLYWHEEL later in this group.
2. Drill two small holes approximately 20 apart in bottom
of seal casing. Install sheet metal screws in seal
casing with JDG22 Seal Remover attached.
NOTE: It may be necessary to drill a small hole in seal at
one or two other locations to aid in removal.
3. Cock seal at 6 o'clock position (180 opposite drilled
hole) using a small punch and carefully pull seal from
housing.
Removing Rear Oil Seal
Continued on next page
RG,RG34710,1150
1923OCT971/3