TM 5-3805-281-24-2
Crankshaft, Main Bearings, and Flywheel
TO INSTALL FRONT WEAR SLEEVE:
1. Coat I.D. of new wear sleeve with LOCTITE 609
Retaining Compound.
2. Using JDG467 Driver from JDE3 Installer along with
washer and 5/8-11 UNC x 3 in. cap screw that secures
damper pulley assembly to crankshaft. TIghten cap
screw until driver bottoms.
3. Remove installation tools and clean any sealant from
O.D. of wear sleeve or I.D. of seal bore.
Tool for Installing Front Wear Sleeve
Installing Front Wear Sleeve
Continued on next page
RG,RG34710,1155
1923OCT976/7
11-213