TM 5-3805-281-24-2
Lubrication System
INSTALL OIL COOLER ASSEMBLY:
1. Install oil cooler using a new gasket on each side of
cooler. Be sure gaskets are properly aligned with cap
screw holes.
NOTE: If cover, tubes, and adapter were disassembled,
lubricate new O-rings with clean engine oil.
2. Install a new gasket on cylinder block and install oil
cooler cover, tubes, and adapter as an assembly.
Tighten adapter cap screws to 47 Nm (35 lb-ft).
Sequence for Tightening Cover Screws
3. Tighten oil cooler cover cap screws in sequence shown
(1-8). First tighten to 27 Nm (20 lb-ft). Then retighten
in same sequence to final torque of 37 Nm (27 lb-ft).
RG,RG34710,1219
1923OCT972/2
11-287