TM 5-3805-281-24-2
Lubrication System
REMOVE AND INSTALL OIL PUMP OUTLET
TUBE AND OIL COOLER CROSSOVER TUBE
ADAPTER
REMOVE ADAPTER:
1. Remove oil pump (shown removed). (See REMOVE
ENGINE OIL PUMP, earlier in this group.)
2. Remove two cap screws securing adapter (A) to
cylinder block and remove adapter with oil cooler
cross-over tube (B).
Oil Cooler Crossover Tube and Adapter
3. Clean all gasket material from mating surfaces and
discard.
INSTALL ADAPTER:
NOTE: Be sure gasket is positioned so that offset
matches adapter to avoid blocking oil passages.
1. Lubricate new O-ring with clean engine oil and install
adapter (with cross-over tube) using a new gasket.
Make sure tubes are properly positioned in each O-ring
bore.
2. Tighten cap screws to 54 Nm (40 lb-ft).
3. Install engine oil pump assembly. (See INSTALL
ENGINE OIL PUMP, earlier in this group.)
RG,RG34710,1232
1923OCT971/1
