TM 5-3805-281-24-2
Robert Bosch Alternator Repair
30
10
If no fault is found in the above described test, carry out
10
this test with reversed polarity (see illustration).
Meter must show continuity.
NOTE: Test voltage 6--12 volts DC.
RG,RG34710,2163
1915MAR972/2
DIODE PLATE INSTALLATION
Pay attention to perfect insulation connections "B+", "D+"
and the positive diode heat sink in respect to end frame.
Install diode plate as shown and tighten screws.
RG,RG34710,2164
1915MAR971/1
SOLDERING STATOR COILS
IMPORTANT: Use only rosin core solder.
Make sure that no solder seeps inside diode plate.
Avoid overheating diodes.
RG,RG34710,2165
1915MAR971/1
PRESSING BALL BEARING ONTO ROTOR
SHAFT
For pressing on, use a sleeve which presses against the
ball bearing inner race.
IMPORTANT: Never press onto drive end frame;
damage may result.
RG,RG34710,2166
1915MAR971/1
