Robert Bosch Alternator Repair
PRESSING ROTOR INTO DRIVE END FRAME
Use a new retaining plate (A) when installing new ball
Apply high temperature bearing grease such as Bosch
Ft70v1 or Delco Remy No. 194891 to end frame bearing
seat. Place spring washer end in frame and carefully join
both alternator halves, paying attention to markings.
Tighten screws (A) to 4--5.5 Nm (33--48 lb-in.)
INSTALLING BRUSH HOLDER WITH
Carefully insert brush holder with regulator. Make sure
that gasket (A) fits correctly. Tighten screws securely.
FAN AND BELT PULLEY--INSTALLATION
Tighten securing nut to 35--45 Nm (25--32 ft-lb).
NOTE: To install alternator and adjust belt tension, refer
to machine technical manual.