TM 5-3805-281-24-2
01--Screw (3 used)
10--Screw with Washer (2
15--Rubber Bushing (2
26--Pipe (2 used)
03--Support
used)
used)
28--Tie Band (3 used)
04--Air Duct
11--Cap Screw, Lock
16--Rubber Bushing
29--Tray
05--Cap Screw, Lock
Washer, Washer (4
17--Plug (16 used)
30--Screw (4 used)
Washer, Washer (10
used)
23--Hose
used)
13--Rubber Bushing
24--Hose
09--Air Duct
14--Rubber Bushing
25--Hose Clamp (4 used)
2. Remove and install blower motor and heater core.
3. Tighten hose clamps (25) until hose just starts to
deform around clamp.
CED,OUOE027,247
1918MAY983/3
REMOVE AND INSTALL HEATER HOSES
CAUTION: Explosive release of fluids from
pressurized cooling system can cause serious
burns.
Shut off engine. Only remove filler cap when
cool enough to touch with bare hands. Slowly
loosen cap to first stop to relieve pressure
before removing completely.
1. Close shut-off valves on engine or drain coolant from
radiator. The approximate coolant system capacity is
30 L (8 gal).
CED,OUOE027,248
1918MAY981/3
Continued on next page
18
1830
15