TM 5-3805-281-24-2
Buckets
REPAIR CRACKED CUTTING EDGE
33
2. For any crack in cutting edge, clean the area to find
IMPORTANT: Electrical current traveling from the
3302
end of crack.
welder through the machine's
10
electrical system may damage the
3. Drill a small hole at end of crack to prevent
electrical system, including the
spreading.
battery, and the engine and pump
controller. Before welding on the
4. Grind a V-groove along crack on top and bottom of
machine, the battery ground cable
cutting edge.
and wiring harness connectors to
the engine and pump controller must
5. Preheat the cracked area to approximately
be disconnected to protect the
149--260C (300--500F).
machine's electrical system.
6. Fill the V-grooves with weld. Use E7018 electrodes.
1. Disconnect battery ground strap and wiring harness
Extend the weld approximately 13 mm (0.5 in.)
connectors to engine and pump controller. (See
beyond end of crack.
Welding on Machine in this group.)
TX,33,GG2398 1914DEC961/1