TM 5-3805-281-24-2
Buckets
33
3302
7
5. Install shank into corner so it is tight against bevel
IMPORTANT: Good welds are important. Have only
edge and side of bucket.
a qualified welder do the welding.
Before welding, clean all dirt and
Install center shanks so they are tight against bevel
paint from weld area. Connect the
edge and spaced equally across width of bucket.
welder ground clamp as close to
each weld area as possible so
6. Tack weld at top rear center to hold it in position.
electrical current does not pass
through any bearings or bushings.
Use E7018 electrodes for welding or Lincoln
Electric Co. gasless flux core process electrode
4. Before welding shank, remove tooth tip so rubber
type NS3M. 3/32 or 1/8 in. rod may be used.
pin lock is not damaged by heat.
Continued on next page
TX,33,GG2396 1913DEC963/4
19-7