TM 5-3805-281-24-2
Hydraulic System
12. Heat housing to 80--100C (176--270F). Apply
multi-purpose grease to inside of housing and to
33
O-ring groove.
3360
42
13. Install drive shaft (A).
14. Apply multi-purpose grease to O-ring (B) and install
O-ring in housing.
15. Install oil seal (C) in cover.
A--Drive Shaft
B--O-Ring
C--Oil Seal
CED,OUOE027,299
1904JUN987/14
16. Install cover (A) and snap ring (B). Make sure snap
ring is installed properly in snap ring groove.
A--Cover
B--Snap Ring
Continued on next page
CED,OUOE027,299
1904JUN988/14
19-80