TM 5-3805-281-24-2
Hydraulic System
3--Maximum Flow
16--Minimum Flow
21--O-Ring (2 used)
31--Cap Screw (8 used)
Adjusting Screw (Stop)
Adjusting Screw
22--Inner Spring
32--Lock Washer (8 used)
6--O-Ring (3 used)
17--Nut (2 used)
23--Outer Spring
33--End Plate
33
9--Remote Control Sleeve
18--Nut (2 used)
24--Load Sleeve
34--Cap Screw (4 used)
3360
10--Remote Control Spool
19--Load Adjusting Screw
25--Load Spool
35--Lock Washer (4 used)
51
11--Housing
(Stop)
26--Cylinder
36--Air Bleed Plug
12--Spring
20--Load Adjusting
27--Load Piston
37--O-Ring
13--Piston
Cartridge (Stop)
28--O-Ring
38--Cover
14--Cylinder
--Flow Adjusting Cartridge
29--Backup Ring
15--Nut
(Stop)
30--O-Ring
7. Remove air bleed plugs from pump regulator. Install
IMPORTANT: Hydraulic pump will be damaged if
regulator making sure groove in remote control
not filled with oil before starting
sleeve (9) and load sleeve (24) engage dowel pin in
engine. Procedure must be
feedback link. Check through hole that groove in
performed whenever a new pump is
sleeves engage dowel pin.
installed or oil has been drained
from the pump or hydraulic oil tank.
Tighten cap screws (34).
8. Fill pump housing with oil. (See Hydraulic Pump
Housing-to-Pump Housing Cap Screw--Specification
and Splitter Drive Start-Up Procedure in this group.)
Torque....................................................................... 49 Nm (36 lb-ft)
9. Check pump regulator adjustments. (See Hydraulic
Pump Regulator Test and Adjustments in Group
Tighten air bleed plug.
9025-25.)
Air Bleed Plug-to-Housing--Specification
Torque....................................................................... 78 Nm (58 lb-ft)
CED,OUOE027,300
1905JUN984/4
19-88
