TM 5-3805-281-24-2
Hydraulic System
33
3360
127
A--Hydraulic Oil Tank
E--Hydraulic Oil
I--Lock Washer (4 used)
L--Hydraulic Oil
B--Hydraulic Oil
Tank-to-Front Pump
J--Cap Screw (4 used)
Tank-to-Control Valve
Tank-to-Rear Pump
Regulator Side Port
K--Hydraulic Oil
Rear Pump Control
Regulator Side Port
F--Test Point
Tank-to-Control Valve
Valve Bottom Left Port
C--Clamp
G--Test Point
Right Side Rear Right
M--Clamp
D--Cap Screw
H--Washer (4 used)
Port
N--Cap Screw
13. Disconnect lines (B, E, K and L). Install caps and
CAUTION: The approximate weight of
plugs.
hydraulic oil tank is 150 kg (331 lb).
14. Disconnect wiring harness from test points (F and
Hydraulic Oil Tank--Specification
G).
Weight ..................................................... 150 kg (331 lb) approximate
15. Remove cap screws (D and N) to remove clamps
Remove hydraulic oil tank using a hoist and lifting
(L and M).
straps.
16. Remove water separator. (See procedure in Group
19. Repair or replace parts as necessary.
0560.)
20. Install hydraulic oil tank.
17. Remove harness clamps as needed.
18. Remove cap screws (J), lock washers (I) and
washers (H) from bottom of tank.
Continued on next page
CED,OUOE026,2
1911JUN987/8
19-156