TM 5-3805-281-24-2
Mechanical Drive Elements
22. Install roller bearing (B) and pinion shaft (C).
23. Install snap ring (A).
24. Place swing gearbox in a vertical position with output
shaft facing up. Apply plastic gasket to the seal bore.
43
4350
17
A--Snap Ring
B--Roller Bearing
C--Pinion Shaft
CED,OUOE027,259 1919MAY9814/19
25. Apply plastic gasket to oil seal (C) bore in cover (A).
IMPORTANT: Seal must be installed as shown or oil
will leak from swing gearbox and
gearbox will fail.
26. Install oil seal (C) into cover (A) so flat metal face (E)
is towards bottom of bore.
A--Cover
C--Oil Seal
E--Flat Metal Face
Continued on next page
CED,OUOE027,259 1919MAY9815/19
21-16