TM 5-3805-281-24-2
Mechanical Drive Elements
27. Clean mating surface of cover (A) using cure primer.
Apply plastic gasket to cover. Apply multi-purpose
grease to lips of seal (C).
Install cover (A) by turning cover back and forth while
pushing down. Make sure seal lips are not rolled
over. Use a blunt flat tip screwdriver to lift lips. Make
sure screwdriver tip has no burrs or sharp edges.
43
Tighten cap screws (B).
4350
18
Cover-to-Housing Cap Screw--Specification
Torque ............................................................................. 88 Nm (65 lb-ft)
A--Cover
B--Cap Screw (10 used)
C--Oil Seal
D--Pinion Shaft
CED,OUOE027,259
1919MAY9816/19
28. Turn gearbox onto output shaft. Install parts (A--C).
A--Second Planet Pinion Carrier
B--Second Planet Sun Gear
C--O-Ring
Continued on next page
CED,OUOE027,259
1919MAY9817/19
21-17