TM 5-3805-294-23-1
0016
Table 1. DTC 94.04 - Low-Pressure Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Disconnect engine wiring
22.
Short Circuit
harness connector J02.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
47)
Socket C2 and all
Other Sockets on
Engine Wiring
Harness Connector
J02.
2.
Measure resistance (Volume
1.
If any measurement was less
than 100 kohms, replace
3, WP 0369) between engine
engine wiring harness
wiring harness connector J03
socket C2 (Volume 5,
(Volume 4, WP 0510) and
replace engine interface wiring
WP 0800, Figure 48) and all
harness. (Volume 4,
other sockets on engine wiring
harness connector J02.
WP 0509) Restore machine to
original condition and perform
(Volume 5, WP 0800, Figure
Harness Diagnostic Mode
47) Note readings.
Test. (Volume 3, WP 0345)
2.
If all measurements were
greater than 100 kohms,
reconnect all connectors and
proceed to Malfunction 23.
1.
Turn key switch to ON position,
23.
Check DTC 94.04
but DO NOT START ENGINE
For Active Status.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Clear and refresh DTCs. Note
if DTC 94.04 is still an active
DTC. (Volume 3, WP 0362)
3.
Turn key switch to OFF
1.
If DTC 94.04 is still an active
position (TM 5-3805-294-10).
DTC, problem was not found
and may have been missed
(Volume 5, WP 0794)
during troubleshooting.
Restart procedure at
Malfunction 1.
If DTC 94.04 is not an active
2.
DTC, problem corrected.
END OF WORK PACKAGE
0016-12