TM 5-3805-294-23-1
0016
Table 1. DTC 94.04 - Low-Pressure Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
11.
Turn the key switch to the OFF
1.
If voltage fluctuated, replace
position (TM 5-3805-294-10).
engine wiring harness.
(Volume 5, WP 0794)
(Volume 4, WP 0510) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
2.
If voltage did not fluctuate,
proceed to Malfunction 10.
1.
Replace sockets in engine
10.
Engine Interface
interface wiring harness
Wiring Harness
connector P03 (Volume 4,
Connector P03
Sockets and Fuel
WP 0511) or replace engine
Transfer Pump
interface wiring harness.
Pressure Sensor
(Volume 4, WP 0509)
Are Faulty.
2.
Replace fuel transfer pump
pressure sensor. (Volume 3,
WP 0431)
3.
Clear and refresh DTCs. Note
1.
If DTC 94.04 is still active, it is
if DTC 94.04 is still an active
possible that another fault
exists or that another
DTC. (Volume 3, WP 0362)
troubleshooting procedure
applies. If this was the first time
through this procedure, restart
procedure at Malfunction 1.
2.
If DTC 94.04 is not active,
problem corrected.
1.
Turn key switch to ON position,
11.
Check for DTC
but DO NOT START ENGINE
3510.04.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Refresh DTCs. Note if DTC
3510.04 is an active DTC.
(Volume 3, WP 0362)
0016-7