TM 5-3805-294-23-1
0016
Table 1. DTC 94.04 - Low-Pressure Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance (Volume
1.
If greater than 5 ohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
interface wiring harness
connector P03 socket 1
WP 0509) Restore machine to
original condition and perform
(Volume 5, WP 0800, Figure
Harness Diagnostic Mode
55) and engine interface wiring
harness connector I01 pin 1.
Test. (Volume 3, WP 0345)
(Volume 5, WP 0800, Figure
2.
If less than 5 ohms, replace
44) Note reading.
engine wiring harness.
(Volume 4, WP 0510) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
Measure resistance (Volume
1.
If less than 10 kohms, proceed
4.
Short Circuit
to Malfunction 5.
Between Engine
3, WP 0369) between engine
Interface Wiring
interface wiring harness
2.
If greater than 10 kohms,
Harness Connector
connector P03 socket 1 and
proceed to Malfunction 6.
P03 Sockets 1 and
socket 3. (Volume 5,
3.
WP 0800, Figure 55) Note
reading.
1.
Disconnect engine wiring
5.
Short Circuit
harness connector I01.
Between Engine
Interface Wiring
(Volume 5, WP 0800, Figure
Harness Connector
44)
I01 Pins 1 and 4.
2.
Measure resistance (Volume
1.
If less than 10 kohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
interface wiring harness
connector I01 pins 1 and 4.
WP 0509) Restore machine to
original condition and perform
(Volume 5, WP 0800, Figure
Harness Diagnostic Mode
44) Note reading.
Test. (Volume 3, WP 0345)
2.
If greater than 10 kohms,
replace engine wiring
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
0016-3