TM 5-3805-294-23-1
0015
Table 1. DTC 94.03 - Low-Pressure Fuel Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
10.
Select Yes to terminate your
readings connection. (Volume
3, WP 0363)
11.
Turn key switch to OFF
1.
If voltage fluctuated, replace
position (TM 5-3805-294-10).
engine wiring harness.
(Volume 5, WP 0794)
(Volume 4, WP 0510) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
2.
If voltage did not fluctuate,
proceed to Malfunction 20.
1.
Turn key switch to ON position,
20.
Check DTC 94.03
but DO NOT START ENGINE
For Active Status.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Clear and refresh DTCs. Note
if DTC 94.03 is still an active
DTC. (Volume 3, WP 0362)
3.
Turn key switch to OFF
1.
If DTC 94.03 is still an active
position (TM 5-3805-294-10).
DTC, problem was not found
and may have been missed
(Volume 5, WP 0794)
during troubleshooting.
Restart procedure at
Malfunction 1.
If DTC 94.03 is not an active
2.
DTC, problem corrected.
1.
Replace ECU. (Volume 4,
21.
ECU is Faulty.
WP 0508)
2.
Reconnect all connectors.
3.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
4.
Perform Harness Diagnostic
Mode Test. Note if DTC 94.03
is still an active DTC. (Volume
3, WP 0345)
0015-11