TM 5-3805-294-23-1
0015
Table 1. DTC 94.03 - Low-Pressure Fuel Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Disconnect engine wiring
10.
Open Circuit
harness connector I01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
44)
Socket H3 and
Engine Wiring
Harness Connector
I01 Socket 1.
2.
Measure resistance (Volume
1.
If greater than 10 ohms,
replace engine wiring
3, WP 0369) between engine
harness. (Volume 4,
wiring harness connector J03
socket H3 (Volume 5,
WP 0510) Restore machine to
original condition and perform
WP 0800, Figure 48) and
Harness Diagnostic Mode
engine wiring harness
connector I01 socket 1.
Test. (Volume 3, WP 0345)
(Volume 5, WP 0800, Figure
2.
If less than 10 ohms, replace
44) Note reading.
engine interface wiring
harness. (Volume 4,
WP 0509) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
Measure resistance (Volume
1.
If greater than 10 ohms,
11.
Open Circuit
proceed to Malfunction 12.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
2.
If less than 10 ohms, proceed
Connector J03
socket H4 and (Volume 5,
to Malfunction 13.
Socket H4 and
WP 0800, Figure 48) engine
Engine Interface
interface wiring harness
Wiring Harness
connector P03 socket 2.
Connector P03
(Volume 5, WP 0800, Figure
Socket 2.
55) Note reading.
1.
Disconnect engine wiring
12.
Open Circuit
harness connector I01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
44)
Socket H4 and
Engine Wiring
Harness Connector
I01 Socket 5.
0015-6